Natural Anodised 2 Inch Aluminum Corner Trim , ODM Aluminum Wall Protection

Internal Corner Aluminium Panel Trim Wall UV Board Protection Decoration

 

Application
 

Surface Finish:

• Natural anodised finish

• Mill (untreated) finish

Please contact us if you require a surface finish that is not shown.

N.B. Jig or clamp marks on anodised items can be unsightly, and are normally positioned up to 50mm in from each end. When aesthetic considerations apply, these markings should be cut away.

Feature

Paint & Powder Coating: BS 6496 (1984)

Specification for powder organic coatings for application and stoving to aluminium alloy extrusions,sheet and pre-formed sections for external architectural purposes, and for the finish on aluminium alloy extrusions, sheet and preformed sections coated with powder organic coatings.

Use
 

Mill finish (untreated)

External applications

When used externally mill finish aluminium requires regular cleaning to maintain a relatively good standard of appearance. The frequency and cleaning method suggested is dependent on the local environmental conditions.If a cleaning programme is adopted from outset, the surfaces concerned will respond to the following treatment:

• Remove any grease or oil deposits with organic solvent such as white spirit.

• Swab down with a diluted solution of mild detergent followed by rinsing with clean cold water.To retain a reasonable surface appearance, frequency of cleaning will vary from once or twice a year in rural areas;to three or four times per year in mild industrial areas; to once monthly in severely polluted or marine environments.Cleaning long established but neglected installations of aluminium will probably require one or more of the following methods, depending on the severity of the surface contamination.

• Bristle brush and dilute detergent e.g. Fairy Liquid

• Polishing compounds e.g. Brasso

• Nylon pad impregnated with abrasives e.g. Scotchbrite

• Steel wool in conjunction with dilute detergent

Specification